Snappi Diaper Fasteners

The Snappi works best on Diaper Service Quality prefolds or other loose weaves like terry cloth.  It is OK on Kissaluvs Contours but not recommended for felt or other closed-weave diapers.

The three ends of the Snappi have little hooks that grab the diaper without ripping it. Attach the sides first, then draw down the middle to hold it on tight. The “T” shape turns into a “Y” shape when properly attached to the diaper.

The Snappi fastener is manufactured from FDA approved raw materials, a polyester based polyurethane which is degradable on aging through hydrolysis and/or microbiological attack. It contains NO latex or any other adulterant, dilutent or modifying polymers. The composition is 100% polyurethane. It is made in South Africa.

Pack contains 2 fasteners.   

Important Notes and Disclaimers:

WARNING:
1. ALWAYS use a cover when using a Snappi® fastener with your baby’s diaper.
2. Keep out of children’s reach when not in use!
3. Do NOT use a Snappi® fastener on toddlers that have the ability to undo their cover and take off their diaper and/or clothes.
4. Do not use your Snappi® for longer than 6 months.
5. Do not leave your Snappi® lying in the sun as it is not UV resistant and can reduce the effectiveness of the Snappi®.

CARE: Clean your Snappi® in hot soapy water. Do not launder them with diapers in the washer as this may weaken the grip attachment.

CAUTION:

• Any tear in the Snappi® can lead to separation of a piece, presenting a possible choking hazard. 
• Do not cut your Snappi® as this could create weak spots in your Snappi®. 
• Do not pull on the side strips of the Snappi® when attaching it, as this can cause them to break.  These strips serve as a safety feature only, as explained above.  Use the flat tabs for leverage. 
• Inspect your Snappi® before each use and discontinue use immediately if there is any sign of cracking, tearing, breakage or wear of the teeth or any other parts.

EXTRA SAFETY FEATURE!
The Snappi® fastener underwent a ‘makeover’ in 2006. The basic shape and function remains the same, the only change being that the rings at the end of each leg have been replaced with a solid piece embossed with the Snappi® logo and a crescent-shaped loop at the end of each leg, which gives the Snappi® this EXTRA SAFETY FEATURE.

When the Snappi® fastener is not in use, fold the loop over the back of the Snappi® end to fit over the teeth of the white grip - see photo above. This acts as a barrier and prevents the sharp teeth from being exposed. These loops are NOT to be pulled on when attaching the Snappi® fastener to the diapers.  When attaching the Snappi®, hold onto the solid part of the tab.

WARNING: Keep all Snappi® fasteners out of children’s reach when not in use.